WWW.CLF-LIGHTING.COM
7
power and signal connection
POWER SUPPLY:
Use powerCON plug to connect the fixture to the main power supply.
Please check if the voltage and the frequency are the same as mentioned on the fixture.
SIGNAL CONNECTION:
Please use the 5 pin XLR connectors to connect the first fixture’s DMX output to the next fixture’s input, and so on.
As connect in the following figure.
WWW.CLF-LIGHTING.COM
9.0
power and signal connection
POWER SUPPLY:
Use the professional plug to connect the projector to the main power supply. Please check
if the voltage and the frequency are the same as mentioned on the projector. When each
SIGNAL CONNECTION:
s output to the
s input. And
in the same way for the rest, eventually connect the last device’s output, all the devices are
The device control signal output and input uses the 5-pin XLR plug and socket.
The communicate cable is a 2-pin shielded cable of 1
10Ω.
The resistance of each core is at least a diameter of 0.5mm.
(
Notice:
The inside leading wire of the 3/5-pin XLR plug can’t
touch each other or the
plinth
). We recommend to use the DMX
signal terminator during the installation to avoid electronic noise
damage of the digital control signal. Simply speaking, the DMX
terminator is a XLR connector with a 120Ω & 1/2W resistor
connected across pin 2 and 3 (see picture on the right). Which
Refer to the connection as in above picture. We advise to use
a DMX signal distributor when the distance of the lights is more
then 15 meter, to prevent signal loss.
The resistance of each core is at least a diameter of 0.5mm. (
Notice:
The inside leading wire
of the 5-pin XLR plug can’t touch each other or the earth). We recommend to use the DMX
signal terminator during the installation to avoid electronic reflection of the digital control
signal. The DMX terminator is a XLR connector with a 120Ω & 1/2W resistor connected across
pin 2 and 3 (see picture on the right). Which is plugged into the output socket on the last
fixture in the chain. Refer to the connection as in above picture. We advise to use a DMX
signal distributor when the distance of the lights is more then 15 meter, to prevent signal loss.
WWW.CLF-LIGHTING.COM
9.0
power and signal connection
POWER SUPPLY:
Use the professional plug to connect the projector to the main power supply. Please check
if the voltage and the frequency are the same as mentioned on the projector. When each
SIGNAL CONNECTION:
s output to the
s input. And
in the same way for the rest, eventually connect the last device’s output, all the devices are
The device control signal output and input uses the 5-pin XLR plug and socket.
The communicate cable is a 2-pin shielded cable of 1
10Ω.
The resistance of each core is at least a diameter of 0.5mm.
(
Notice:
The inside leading wire of the 3/5-pin XLR plug can’t
touch each other or the
plinth
). We recommend to use the DMX
signal terminator during the installation to avoid electronic noise
damage of the digital control signal. Simply speaking, the DMX
terminator is a XLR connector with a 120Ω & 1/2W resistor
connected across pin 2 and 3 (see picture on the right). Which
Refer to the connection as in above picture. We advise to use
a DMX signal distributor when the distance of the lights is more
then 15 meter, to prevent signal loss.