Use of the CLEW Pre Rider Binding
Before the first ride
Strap the binding with the highback attached to the base
1. Open all straps.
2. Remove snow, ice and dirt from your softboot and put your foot in the first binding.
Make sure your heel pushes against the highback.
3. Close both straps: Push the ratchet band as far as possible into the buckle and
tighten the strap by moving the lever alternately forward and backward. For ideal
grip, see also page 9.
4. Repeat steps 2 and 3 for the second binding.
5. Off to the slopes!
On the slopes
Step out
Pull the red handle on the highback, and step out first with your heel and then the
whole foot.
Step in
Step in with your toes first and guide your foot to the toe strap. Then lower the heel
until you click in the lowest position. Check the locking mechanism by trying to
get out without using the pull handle. Do not ride until you are sure that the locking
mechanism is locked.
At the end of a snowboard day
Open all straps to step out
Pull the levers of the buckles and pull the ratchet off the ratchet band. Then simply
step out of binding, see also page 9.
11 / 19