Clevo W330AU, User Manual

Page: 231 / 260

PC Camera Module (Windows 7) E - 17
Windows 7
Windows 7
PC Camera Driver Installation
1. Make sure the module is powered on, and then insert the Device Drivers &
Uti User’s Manual disc into an attached DVD drive.
2. Click Option Drivers (button).
3. Click 1.Install Webcam Driver > Yes .
4. Click Finish to restart the computer.
5. Run the camera application program from the desktop shortcut (if the hard-
ware is turned off use the Fn + F10 key combination to turn it on again).
PC Camera Audio Setup
If you wish to capture video & audio with your camera, it is necessary to setup the
audio recording options in Windows .
1. Click Start , and click Control Panel (or point to Settings and click Control Panel ).
2. Click Sound ( Hardware and Sound ).
3. Click Recording (tab).
4. Right-click Microphone and make sure the item is not disabled.
5. Double-click Microphone (or select Properties from the right-click menu).
6. Click Levels (tab), and adjust the Microphone and Microphone Boost sliders to
the level required.
7. Click OK and close the control panels.
8. Run the camera application program from the desktop shortcut.
9. Go to the Devices menu heading and select Digital Mic ( Realtek High Definition
Audio ) (it should have a check alongside it).
10. Go to the Capture menu heading and select Capture Audio (it should have a
check alongside it).

PC Camera Screen
Refresh
The PC Camera module
supports a frame rate of
12 fps. If you find that
the screen refresh rate
is subject to lag or stut-
tering, then
reduce the
window size , or adjust
the Output Size and/or
Color Space Compres-
sion
.
To reduce Output Size
and/or Color Space
Compression run the
camera application,
click
Options and select
Video Capture Pin . Ad-
just the settings from the
appropriate pull-down
menu.