Clevo W270CZQ, Service Manual

Page: 32 / 94

Disassembly
Removing the System Memory (RAM) 2 - 9
2.Disassembly
Removing the System Memory (RAM)
Figure 5
RAM Module
Removal
a. Remove the screws.
b. The RAM modules will
be visible at point
on the mainboard.
7
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
DDRIII (DDR3) Up to 1066/1333 MHz. The main memory can be expanded up to 8GB. The SO-DIMM modules sup-
ported are 1024MB and 2048MB
DDRIII Modules. The total memory size is automatically detected by the POST rou-
tine once you turn on your computer.
Memory Upgrade Process

6. Component Bay Cov-
er
• 4 Screws
1. Turn off the computer, turn it over and remove the battery ( page 2 - 5 ).
2. Remove screws
-
from the component bay cover ( Figure 5a ).
3. Carefully ( a fan and cable are attached to the under side of the cover ) lift up the bay cover.
4. Carefully disconnect the fan cable , and remove the cover (note that you need to raise the bottom cover up
to an angle of around 30° angle).
5. The RAM modules will be visible at point on the mainboard ( Figure 5b ).
1 4
5 6
7
a.
1
2
3
4
6
10
5
7
6
b.