Disassembly
2 - 12 Removing the System Memory (RAM) from Under the Keyboard
2.Disassembly
Removing the System Memory (RAM) from Under the Keyboard
The computer has
four
memory sockets for 260 pin Small Outline Dual In-line (SO-DIMM)
DDR 4
type memory modules.
The total memory size is automatically detected by the POST routine once you turn on your computer.
Two primary memory sockets are located under component bay cover (the bottom case cover), and two secondary
memory sockets are located under the keyboard
.
If you are installing only two RAM modules then they should be in-
stalled in the primary memory sockets under the component bay cover.
Memory Upgrade Process
1.
Turn
off
the computer, and turn it over, remove the battery (
2.
Remove the screw
a
).
3.
Open it up with the LCD on a flat surface before pressing at point
to release the keyboard module (use an eject
stick
with a diameter no bigger than 2.5mm) to do this while releasing the keyboard in the direction of the
arrow
as shown (
).
Figure 7
Keyboard
Removal
a. Remove the screw.
b. Eject the keyboard
using a special eject
stick to push the
keyboard out while
releasing the key-
board as shown.
1
2
3
4
3. Eject Stick
•
1 Screw
2
a.
b.
1
3
4
Summary of Contents for P870DM
Page 1: ...P870DM P870DM G ...
