Disassembly
Removing the Hard Disk Drive 2 - 7
2.Disassembly
Removing the Hard Disk Drive
The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 7mm
(h). Follow your operating system’s installation instructions, and install all necessary drivers and utilities (as outlined in
Chapter 4 of the User’s Manual
) when setting up a new hard disk.
Hard Disk Disassembly Process
1.
Turn
off
the computer, and remove the battery (
page 2 - 5
).
2.
Remove the SD card cover
and screws
-
(
Figure 3a
).
3.
Carefully push to release the bottom case
from point
and then lift it up from point
to release the bottom
case and ports as indicated by the arrows (
Figure 3b
)
.
4.
The HDD will be visible at point
on the mainboard (
Figure 3c
)
.
6
1
2
17
18
19
20
21
2
a.
b.
1
3
4
5
18
13
21
6
7
8
9
11
12
14
15
10
c.
18
19
16
20
17
Figure 3
HDD Assembly
Removal
a. Remove the SD card
cover and screws.
b. Remove the bottom
case.
c. Locate the HDD.
18. Bottom Case
•
16 Screws
Summary of Contents for N870HZ
