![background image](http://html.mh-extra.com/html/clevertronics/ts-trade-series/ts-trade-series_installation-and-maintenance-instructions_2623564002.webp)
1942193
V1.2
13 January 2022
Instruction Sheet Template - V1.2
–
Updated 06/10/2021
Installation:
The Boxlite LED Exit (EBLLED-LI) is available as wall or ceiling mount. The back plate is attached to the
wall or ceiling using screws installed through the 4 mounting holes. Once the base is mounted and wired
the fitting body and diffuser are installed. Please follow the steps below to install the Boxlite Exit (also see
Figure 1 below):
•
Remove the diffuser.
•
Unscrew the body from the base plate and disconnect the power connector to separate the two
parts.
•
Route the power cable through the entry hole of the base plate.
•
Position the base plate in the mounting position.
•
Mark the 4 holes for mounting. Then install the base using appropriate fixings (not supplied).
•
Connect the 240VAC supply to the mounting bracket. L, N & E terminals are marked on the base
plate in front of the terminals.
•
Reconnect the power connector between the fitting body and the base plate.
•
Screw the fitting body onto the base plate via the specified fixing points.
•
Re-fit the diffuser.
Maintained/Non-Maintained Operating Mode:
Press the Test Button 5 times within a 4 second period to toggle operation of the fitting between
Maintained and Non-Maintained mode.
Boxlite Maintenance:
Lamp Replacement:
•
Use only the LED lamp bar recommended on the label inside the Boxlite.
•
To replace the lamp bar, remove the self-tapping screws, disconnect the signal cable and install the
new lamp bar.
*Please note that the 50,000-hour LED Lamp Bar used in the Boxlite Exit does not suffer from burn out.
Lamp replacement can be done as scheduled maintenance, at >5-year intervals. Please make a note, in
the site logbook, as to when lamps should be changed.
Battery Replacement:
•
Use only the battery recommended on the label inside the Boxlite and on this instruction.
•
Remove the cable ties holding the battery, un-plug the lead from the PCB and remove the old
battery.
•
Clip the new battery into the holder, route the DC cable to the PCB and plug the new battery into
the PCB.
•
Secure the battery using suitable cable ties
Changing Exit Legend Inserts:
The Boxlite Exit uses Clevertronics patented “Tamper proof” Exit legend cover and comes complete with
spare legend inserts to enable straight on, left or right arrow combinations.
To change an Exit legend insert first remove the diffuser. The clear tamper proof cover is held in place
by 4 locking tabs, 2 in the top and 2 in the bottom. Use a tool to disengage and push the locking tabs
through to release the cover and remove the insert, replacing it with the desired one.
To re-install the clear cover, first engage the 2 tabs on the bottom of the cover into their respective
recesses in the diffuser. Once sure the tabs are located, then carefully push the 2 top tabs back in to
complete the process.
Caution:
On many building sites, power circuits may be cut off in an uncontrolled and repetitive basis during
construction. As a result, any Exit & Emergency Units, on these circuits, will have their batteries
discharged or “cycled”. The battery in this fitting has been selected to give excellent long-life
performance in a controlled AS2293 testing environment. Excessive battery cycling will reduce through-
life performance and may lead to premature battery failure. Battery warranty claims, as a result of such
abuse, are specifically EXCLUDED from Clevertronics warranty terms.
Warranty:
For Product Warranty information and Terms and Conditions of Sales please refer to our website
http://clevertronics.com.au/terms-conditions-sale-australia-nz/