1. Lay groundsheet (A) on a flat, even surface, clear of sharp objects.
TIP:
Set up out of direct sunlight with access to an IP66 rated
outdoor socket. Do not use an extension lead.
2. Fully uncoil the lead & plug, located under pump & heating system.
3. Screw Inflation Hose (D) on to Air Outlet (J).
4. Push Inflation Hose (D) into Inflation Valve (K).
5. Plug into mains & switch on. (Do not unscrew inner valve).
6. Press air jets on control panel to start inflation (Light will appear).
7. Once inflated, press air jets on control panel to stop inflation.
TIP: Do not over inflate. You should be able to push your hand
approximately 4-5cm into the top rim using moderate force.
8. Screw Filter Cartridge (B) onto Filter Connector (N), followed by Filter
Protector Cover (C) onto Filter Cartridge (B).
TIP: Clean filters after
every use. Use filter cleaner to prolong the life of your filters
9. Before filling with fresh tap water, please consider the below:
- Where supplied with LED Lights, fit before filling (
see FIG 1
).
- Where supplied with CleverLink® App, locate strongest WiFi signal first
IMPORTANT! Whenever you fill your hot tub with fresh clean water,
you will need to perform a Chlorine ‘Shock Treatment’, to sanitise
the water, destroying any bacteria.
10.
Setting temperature.
Press SET TEMP/LOCK on control panel, then
Temp Up or Temp Down to desired temperature. Press SET TEMP/LOCK
again to confirm.
11.
Clip Top Cover on (E).
TIP: In order to keep your running costs to
a minimum, don’t forget to purchase your EVA Flooring, Inflatable
Cover Support and Thermal Cover.
CLEVERSPA® HOT TUB SETUP
SCAN ME FOR
FILTER CLEANING TIPS
WATER OUTLET/CAP
INFLATION VALVE/CAP
AIR OUTLET/CAP
J
CLIP-ON TOP COVER
GROUND SHEET
DRAINAGE PLUG
FILTER COVER
FILTER CARTRIDGE
FILTER CONNECTOR
WATER OUTLET
G
N
M
E
A
B
C
K
L
Square
I-Beam hot tub
instructions are
the same as
round hot tub
INFLATION HOSE
D