10.
11.
12.
13.
14.
Glue the two halves of the fin and dorsal fin together. Once the
glue is dry, slide the fin into the slot in the top and bottom fuselage
pieces. Glue it to the fuselage. Also glue the dorsal fin to the fin
and fuselage.
Glue the stabilizer halves together. Once the glue is dry slide the
stabilizer into the slot in the fin and glue it in place. Make sure it is
square to the fin.
Bend the main landing gear legs from .025" music wire. Mount
1/2" wheels on the gear legs. Glue the legs to the supports as
shown in the illustration.
Bend the nose gear leg from .025" music wire. Mount a 1/2" wheel
on the gear leg. Glue the leg to the back side of part N using the
lines as a guide. You will have to push the end of the gear leg
through the joint between part N and D.
Glue the pilot figure to the colored rectangle on the fuselage top.
Vacuum form the canopy and glue it to the fuselage. This completes
the model assembly.
Glue the main landing gear supports S to the outside face of the
wing ribs. Use the lines on the ribs as a location guide. Also glue
the nose gear support parts N and D to the bottom of the
fuselage 3/8" back from the nose.
S
S
N
D
N
D
Summary of Contents for E-Zee Thunderstreak F-84F
