Cleva VF408B, Owner'S Manual, Page: 6 / 12

6
A Philips head screw driver is required.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the container. (fig. 3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig. 4)
5. Turn the container upside down and insert the two (2) casters into the slots on the front side of the
container. Apply downward pressure until the casters snap into place. (fig. 5)
6. Slide the rear wheels into the slots making sure to match the wheel number to the corresponding
number on the wheel slot and use screws to secure them. Do not over tighten the screw. (fig. 6 & 7)
7. Your vacuum comes ready for dry vacuum cleaning. If cartridge filter is not installed refer to page 10 for
filter installation. (fig. 8 & 9)
8.
For wet vacuuming: the supplied washable cartridge filter can be used for wet pick-up OR if cartridge filter
is dirty, remove it and place supplied foam sleeve over filter cage for wet pick-up. (Fig. 10) See page 10 for
filter installation.
9. Place the power head back on the container, aligning the top section with the latches, and lock into
place. (fig. 11)
10. Insert the handle into the slots located on the top of the power head and secure it with the screws
provided. Do not over tighten the screw. (fig. 12)
11. Hang the tool caddy to the hooks on the rear of the vacuum. (fig. 13)
12. Secure the large end of the hose onto the vacuum port on the container and screw into place. (fig. 14)
13. Choose the desired accessories and extension wands and push onto the hose. (fig. 15)
LIGHTED PLUG
This vacuum comes standard with a lighted plug that when plugged in lights up showing suer that wall
receptacle is working and that vacuum has power.
GENERAL ASSEMBLY INSTRUCTIONS
WARNING
: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.