4/9
Clenergy China
Tel86 592 311 0088
999-1009 Min'an Rd, Huoju Hi-tech Ind. Dev. Zone
Fac86 592 599 5028
Xiang'an District 361101, Xiamen, Fujian, China
1
．
Friction coefficient reduction
(1) Ensure the thread surface is clean and free of all dirt or contaminants.
(2) Apply lubricant (grease or #40 engine oil) to fasteners prior to tightening to
avoid galling or seizing in the threads.
2
．
General installation instructions
(1) Apply force to fasteners in the direction of the axis of the thread.
(2) Apply force uniformly and maintain required torque.
(3) Professional tools and tool belts are recommended.
(4) Avoid using electric tools for final tightening.
(5) Avoid working at high temperatures.
3
．
Safe Torques
Please refer to the safe torques defined in this guide as shown below. If power
tools are required, Clenergy recommends only low-speed tools. High-speed and
impact drivers increase the risk of bolt galling (deadlock). If deadlock occurs and
you need to cut the fasteners, please ensure that there is no load on the fastener
before cutting. Avoid damaging the anodized or galvanized surfaces.
4. These steps should be applied for every stainless steel nut and bolt assembly.
3.3 Installation Dimensions
All drawings and dimensions in this installation guide are for a generic reference.
The PV-ezRack SolarTripod Lite is optimized to suit the specific conditions for
each project and documented in a construction drawing. As a result, major
