UNPACKING YOUR CLEANER
Unpack your cleaner and ensure that you have a complete set of ac ces so ries as listed below:
1 32mm x 2.5m Hose Assembly
1 32mm Stainless Steel Bent End with
Suction Adjuster
2 32mm Stainless Steel Wands
1 32mm Combination Carpet/Hard Floor
Nozzle
1 32mm Crevice Nozzle
1 32mm Dusting Brush
1 32mm Upholstery/Stair Nozzle
1 32mm Double Taper Tube
5 K1 Disposable Microfi bre Bags (KV10 & 15)
5 K1 Disposable Microfi bre Bags (KV18)
1 Second Stage High Effi ciency (H.E.)
Filter Assembly
Note
: The KV18/1H model is also available with a 38mm toolkit in place of the 32mm toolkit.
GENERAL ASSEMBLY
1. Hose
Fit the threaded end of the hose onto the hose connection on the cleaner and turn in a clockwise
direction to lock into place.
2. Bent Hose End & Extension Wands
To connect extension wands and tools simply push the appropriate items together until secure. To
disconnect fi rmly hold one item and gently twist and pull the other to separate.
OPERATING INSTRUCTIONS
WARNING Before use, operators must be provided with information, instruction and training for
the use of the appliance and the substances for which it is to be used, including the safe method of
removal and disposal of the material collected.
1. Connection to the Electricity Supply
Insert the mains plug into a suitable socket outlet and switch on. When you have fi nished cleaning,
switch off the supply at the outlet socket and unplug. When coiling the mains cable make sure that
any twists or knots in the cable come out at the plug end. DO NOT coil cable from the plug end as
all twists and knots remain in the cable and considerably shorten its life.
2. Cleaner Controls
The following controls are provided:
a) The on/off switch is situated at the rear of the motor head. To switch the appliance on fi rmly press
the part of the switch marked “1”. To switch off press the part of the switch marked “0”.
b) The suction regulator situated on the bent hose end is used to vary the amount of suction power
available. In the closed position maximum suction power is available, in the open position less
suction power is available.
3. Carrying and Storing
The assembled cleaner should only be moved by the carrying handle on top of the motor head
(not
applicable to models on a caddy)
. Do not attempt to lift or drag the machine by the mains lead. The
cleaner must be stored indoors and in a dry environment.
All
Type H vacuum cleaners are supplied with screw-on blanking caps. These are designed
to seal the inlet and exhaust ports to prevent the escape or ingress of hazardous dust during transport
or storage. Whenever this vacuum cleaner is not in use these blanking caps should be used. They
must be removed before use.
