Clemas & Co i-air PRO, Parts And Service Manual

Page: 18 / 49

18
4.2.6 Status menu
Menu structure:
•
Status
▪
Fan stalled: no
▪
Fan locked: no
▪
VOC sensor: OK
▪
TVOC alarm: no
▪
Pressure alarm: no
▪
Dust alarm: no
▪
RTC status: OK
▪
<Back
•
<Quit
NOTE : When the LED indicator on the right side
(Figure 12, pos. 1) lights red an error in the
system has occurred. Go to the Status menu to
determine the nature of the error.
Figure 12
4.2.6.1 Status
Monitoring of alarm status and information about sensor status and status of other subassemblies.
Fan stalled - fan does not run after power supply is ON.
Fan locked - fan shut down due to high difference in pressure.
Pressure sensor - OK: sensor is fully operational.
Pressure alarm - Default setting: alarm is turned off.
Dust alarm - Default setting: alarm is turned off.
RTC - Real Time Clock used in operation schedule.
4.3 Factory reset
After software is downloaded the control module is adjusted to default value i.e. those selected in
the config.h file and set in programme at compilation stage.
When necessary (e.g. loss of service password) the initialization procedure may be done manually.
Please contact service team i-team/TCO. The device serial number and PCB number are required.
4.4 WWW interface
IP address is set by default to 192.168.50.150.
The device grants two access levels
: user and service (respective logins: “user” and “service”) . These
levels are protected by different passwords.
The WWW interface consists of two pages; user settings and service settings. The settings are similar
to those accessed from display/encoder level. The values however are updated in real time. To do
the current reading, push the refresh button to refresh the website.