CLEAR | State of the Art Water Management | 13
TOPSIDE CONTROL
Ionizing
When the mode of the controller is set to “Ion/
Action” and the “Ionizing” light is illuminated
on the controller, the area in the center of the
topside control will illuminate in blue.
Large Dose
Press the center of the logo to engage the
“Large Dose” mode for the number of hours
programmed on the controller. When “Large
Dose” is active, the area in the center of the
topside control will flash in blue. Once the cycle
expires, the controller will go back to “Ion/
Action”, the center area will illuminate in blue
and the flashing will stop. To stop the Large
Dose mode before the cycle finishes, hold
down the button in the center of the logo for 10
seconds.
Turn Off Ionizing
If the mineral level is too high, or you would like
to shut off the ionizing for any other reason,
hold down the button in the center of the logo
for 10 seconds or until the blue light goes off.
Turn On Ionizing
If the ionizing function has been turned off,
press the button in the center of the logo to
turn it back on. The center of the logo will
illuminate in blue to indicate that the system is
ionizing.
Cell Connection
When the mineral cell is unplugged, the
eletrode bars are not under water, or the cell is
worn past its useful life, the light in the center of
the topside control will flash red.
Summary of Contents for CLEAR A-400
Page 1: ...CLEAR State of the Art Water Management 1 U S E R G U I D E...
Page 20: ......
