ClearSpan Value Line 106178, Assembly Instructions Manual

Page: 13 / 23

13
CLEARSPAN
™
VALUE LINE
Revision date: 06.21.08
ANCHOR THE SHELTER
At this point, anchor the shelter. Consult the MUST READ
document for anchoring information and suggestions.
Please call customer service at 1-800-245-9881 for
additional anchoring information.
CAUTION : The anchor assembly is an integral part of
the shelter construction. Improper anchoring may
cause shelter instability and failure of the structure
to perform as designed. Failing to anchor the shelter
properly will void the manufacturer’s warranty and may
cause serious injury and damage.
CORRECT INCORRECT
ATTACH END PANEL ASSEMBLIES
Gather the parts:
• End panel assemblies
• CC6213 Fabric clips (Divide clips equally for both end
panels.)
• Tek screws
• Measuring tape and Scissors
Assembly Procedure:
1. While standing inside the shelter, start at the peak of
the end rafter and pull the solid (plain) end panel over
the top of the rafter so the panel edge is wrapped to the
inside of the rafter.
2. Divide the quantity of fabric clips (#CC6213) in half and
pull the end panel edge over the rafter if needed.
3. Secure the solid end panel in place at the top center of
end rafter with one (1) fabric clip and Tek screw.
4. Take the remaining fabric clips for the first panel and
secure the panel to the back of the rafter using the
clips.
Evenly space the clips and work along the rafter.
NOTE: Secure each fabric clip to the end rafter using
a Tek screw. Position the clip and the Tek screw in a
location that will not contact the main cover when it is
installed.
Actual number of clips may differ from what is
shown in the diagram that follows.
The end panel may be shipped as an untrimmed
rectangular piece. If desired, use scissors (or other
means) to trim the excess end panel material that
remains after the panel is attached.
5. Repeat Steps 1-4 to pull the remaining end panel up
and into position.
6. Continue with the next procedure.
End Panel
End Rafter
T-Fitting
Purlin
End Conduit
ATTACH END CONDUIT ASSEMBLIES
1. Verify that the end conduit of end panel is properly
inserted into the T-fittings.
ATTENTION: Do not allow the end conduit to extend
into the opening that remains for the bottom of the end
rafter.
2. Position the end panel as desired and insert the ends
of the end rafter into the T-fitting of the end conduit.
3. Verify that the rafter pipe is flush with the bottom of
the T-fitting and tighten the Allen screws to secure the
connection.
4. Repeat the steps for the remaining end panel.