15
CLEARSPAN
™
GARAGES & STORAGE SHEDS
Revision date: 08.09.10
7. Thread the D-ring strap through the slit in the cover
pocket, wrap it around the cover conduit, and attach
the strap assembly to the rafter.
NOTE:
Verify that the main cover is centered side-to-
side before attaching the D-ring straps.
8. Repeat the steps for the remaining strap.
NOTE:
Install all D-rings straps on the same side of the
shelter. Attach ratchets directly across from the D-ring
straps on the
same rafter assembly
.
9. Move to the other side of the shelter and attach the
ratchets to the rafters. Use the main cover conduit as a
guide to attach the ratchets to the rafters at the proper
height. Fasten ratchets to the outside of these rafters
using a Tek screw.
10. As previously described, make a slit in the cover
conduit pocket and insert a 3' section of strap through
the slit and around the cover conduit.
11. Thread the plain strap ends into the ratchet and slightly
tighten.
NOTE:
It may be necessary to remove excess strap if it
binds up in the ratchet.
12. Repeat the steps for the remaining ratchet or ratchets.
13. Using additional help (if needed) tighten the main cover
beginning with the ratchets along the side of the shelter
frame.
14. After the side ratchets are tightened, return to the front
and back end wall ratchets and tighten.
NOTE:
Loosen the ratchets if needed to remove
excess strap and tighten. If the main cover is not
centered as desired, the D-ring straps can be
repositioned (higher or lower) as needed and the main
cover retightened.
15. Fold the skirt of main cover down and over the ratchets
and D-ring straps to complete the installation of the
main cover.
ATTACH MAIN COVER (CONTINUED)
