2
Revision date: 08.22.13
Table of Contents
Important Information ..............................................3
End Panel Installation ..............................................5
Shelter Care and Maintenance ................................9
Quick Start Guide .....................................................10
Polycarbonate Panels - 20' Wide ......................11
Polycarbonate Panels - 24' Wide ......................12
Notes ..........................................................................13
TWIN-WALL PC PACKAGE: READ THIS BEFORE YOU
BEGIN
The twin-wall PC package is designed to attach to either
the R020B00001 end frame for the 20' wide roll-form,
or the R024B00001 end frame for the 24' wide roll-form
building
after the end frame is assembled
.
Choose one of the following options to continue:
If you purchased but have not assembled the end
•
frame, stop here, return to the end frame instruction
guide, and continue with those instructions.
If you did not purchase an end frame for a roll-
•
form building but plan to construct an end frame
using customer-supplied materials, review these
instructions before constructing the end frame to
better prepare for the installation of the panels
included in this PC package.
After assembling the end frame, continue with these
instructions to attach the corrugated panels.
ATTENTION:
If you purchased an optional door kit,
consult those instructions and proceed as instructed.
In most instances, the end frame and door frame are
constructed
before
end panels are installed. This allows
for the placement of panels as determined by the position
of the door or doors.
It is the responsibility of the owner/contractor to adjust the
position of the end panels based on the end frame and
the position of the installed door or doors. Consult the
services of a qualified contractor to install the panels if
needed.
IMPORTANT:
Some diagrams throughout this manual
show the outside edges of the end panels installed
aligned with the outside edge of the end rafter legs or
ground posts.
For buildings that include sidewall polycarbonate
panels and hat channel secured to the frame, shift the
position of the end panels as needed so these panels
meet the sidewall panels to create a finished corner.
See the diagrams in the Quick Start section for sidewall
examples.
FRAMING:
None of the frame members (rafter, ground
posts, etc.) supporting the end panels are included
in the end panel kit.
Only the panels and those
components needed to attach the end panels to an
existing frame are included. Fasteners are designed for
metal. If your end wall frame requires different fasteners,
contact your sales representative to purchase additional
fasteners, or purchase the proper fasteners locally.
END CAP (108867):
The 108867 end cap that is shown
in some diagrams applies to
greenhouse buildings
only
. This end cap is supplied with the greenhouse
building components.
The 108867 end cap is not supplied with any twin
wall or corrugated pc package kit.
