11
CLEARSPAN
™
END WALL FRAMING KITS
Revision date: 11.12.14
Secure the End Panel to the End Frame
The frame shown in the following diagrams may differ from the actual frame. Installation steps are the same.
1. With door openings cut, secure the end panel to the door frame using Tek screws and washers. See diagram below.
NOTE:
For the exposed corners of the door frame that remain, cut out a 16" x 16" piece of material
from the
scrap
end panel material
and secure the piece to the exposed corners using Tek screws and washers (if desired).
ATTENTION:
DO NOT secure the end panel to the inside or backside of the door frame tubes
. Some doors kits use
this surface for tracks and brackets. Check the instructions that shipped with the door for additional details.
2. Repeat the steps to install the end wall and end panel for the remaining end of the building if equipped.
3. Install the door or doors according to the instructions included with those components.
4. After doors are installed according to the door manufacturer's instructions, continue with the next procedure to
reattach the bonnet ratchets and main cover.
Secure the end
panel to the inside
surface of the
frame tube using
a Tek screw and
washer.
View shows the
inside surface of
the installed end
panel.
Door Jamb
End Panel
Install Tek
screw here
Inside View
Base Rail
Outside View
