CLEARSPAN
™
GARAGES
20
Revision date: 05.20.16
ATTACH MAIN COVER
Gather parts:
• Main cover (with conduits already inserted)
• Ropes long enough to reach over the frame (provided
by customer)
• Ratchets (1"), Tek screws, and 103620B straps
• Box cutter or utility knife
WARNING:
To prevent damage to the cover and to
prevent serious personal injury, DO NOT attempt to
install the main cover on windy days.
Assembly Procedure
1. To pull the cover over the frame, attach ropes to both
ends of the cover conduit. Wrap the rope around the
conduit a few times to prevent it from slipping off.
NOTE:
Depending on the length of the cover it may
be necessary to attach additional ropes to the cover
conduit between the end ropes by cutting a small
opening in the cover pocket and tying the rope around
the conduit. DO NOT cut through the main cover.
Cut
through the conduit pocket only.
2. With all ropes attached to the cover conduit, lift the
conduit and carry the cover toward the base of the
frame.
3. Toss the ropes over the frame and pull the cover into
position. One person is required at each rope.
4. Once the main cover is pulled into position, center
the cover on the frame and loosely secure the ends
of the cover to the ratchets attached to the end panel
conduits.
NOTE:
Space ratchets evenly along each side of
the shelter and directly across from each other on
the
same rafter assembly
. Consult the Side Profile
diagrams in the Quick Start section for ratchet location
details for your building.
Secure ratchets using the FA4482 Tek screws.
ATTENTION:
Do not tighten the straps at this time.
Use
ropes to temporarily secure the sides of the cover to
the frame if needed.
5. Divide the remaining number of ratchets in half and
place the ratchets on the ground next to the rafter
where they will be attached.
End panel and cover not shown.
Diagram may show a different
shelter length.
Diagram may show a different shelter length.
Ropes
Cover Conduit
Cover
Conduit
Front
Main Cover Bonnet
End
Panel
