17
CLEARSPAN
™
CARPORTS
Visit
www.ClearSpan.com
for additional products and customer assistance.
7. Secure the middle of the panel to the upper hat
channel.
8. Take a second long roof panel and place it on the
frame. The long edge adjacent to the first panel will
overlap the
first rib
of that panel. See black dashed line
below. DO NOT OVERLAP MORE THAN ONE RIB OF
THE ADJACENT PANEL.
INSTALL THE CORRUGATED ROOF PANELS
NOTE:
The top of the second long panel is slid
between the first panel and the 5" wall profile. When
installed correctly, the small 5" wall profile will overlap
both of the long panels.
Keep the lower edges of the long panels aligned.
9. Install Tek screws and washers through the first and
second panels at each hat channel run along the edge
except for the upper hat channel run
. See the black
dashed line in the previous diagram.
10. Select a second 5" wall profile section, place it in
position as shown below, and secure using Tek screws
and washers. Use the arrows below as guides.
Keep panels aligned
NOTE:
The Tek screw at the top of the panel and
closest to the first panel will secure the two long panels
and the two short wall profile sections to the upper hat
channel run.
11. Continue to attach long panels and the 5" wall profile
sections to the frame until all panels are in place.
IMPORTANT:
The 5" wall profile sections
will always
overlap the tops of all long corrugated panels.
12. Read the care and maintenance information that
follows.
