14
t
EChnICal
s
uPPort
: 800.283.5936
gPIo t
ab
This tab allows you to choose a macro associated with each input state: High/Open and Low/
Closed. The VIEW Pro macros are created and used in the same manner as the VIEW legacy
products. Refer to the Dealer Setup Manual, Chapter 11 Section 1 (11-1) for the “Favorites section,”
which explains macros in detail.
The GPIO Tab contains six GPIO components (3x Input Triggers and 3x Relays).
INPUT MACRO ASSIGNMENTS:
In the GPIO Tab you can select previously created Macros from the drop-down list for both or one
Input states High/Open and Low/Closed, these Macros are triggered based on the configured
state and State changes.
RELAY ASSIGNMENTS:
Each of the three relays can be set in three states: None, Normally Open and Normally Closed.
These relays can be triggered to change state between Normally Open and Normally Closed to
trigger an event with the connected devices (projector lifts, motorized screens, lighting, shades,
etc...). These relays can be triggered by system macros (found in Macro Builder) or via TCP/IP and/
or serial control commands.