7
t
eChniCAl
s
uPPort
: 800.283.5936
Pairing the Wireless device
ZONE NAmE SElEcTOR SWiTch
Multiple BluePort NS-BP200 devices may be installed within wireless range of each other. In this
case multiple “BluePort” names are listed on their wireless device when pairing. The Zone Name
Selector rotating switch allows the installer to set one of sixteen (16) preset names for the BluePort.
The switch needs to be set before using the BluePort.
Zone Selector Names
Rotary Position
Zone Name
Rotary Position
Zone Name
0
BluePort
8
Study
1
Master
9
Outside
2
Bedroom
A
Lobby
3
Kitchen
B
Office
4
Dining Room
C
Foyer
5
Living Room
D
Board Room
6
Family Room
E
Lunch Room
7
Great Room
F
BluePort2
hOW TO PAiR WiTh ThE BluEPORT
Momentarily press the
1.
Reset
button on the front of the BluePort to place the BluePort into pair-
ing mode. The status LED will turn on solid while the BluePort is preparing for pairing mode.
Once in pairing mode, the LED will start to blink. The BluePort will remain in pairing mode for
five (5) minutes, or until a device connects.
Open the
2.
Bluetooth
configuration page on your source device (Please refer to the
Bluetooth
instructions for your specific wireless device).
Enable
3.
Bluetooth
on your source device, or start scanning for playback devices.
Look for the device identified by the preset name that has been selected on the BluePort using
4.
the “Set ID” rotary switch and pair with it.
If your device prompts you to enter a pairing code, enter “0000” (Four zeros).
5.
Once paired and connected, the status light on the BluePort will turn off, unless your source
6.
device automatically starts streaming, in which case the LED will turn on for one (1) minute, or
until the source device stops streaming.
Start streaming audio to the BluePort from your source device. The status LED on the BluePort
7.
will glow steady for one (1) minute when a new stream starts. On some wireless devices you
may need to explicitly select
Bluetooth
as the audio output.