Page 2 / Seite 2
English
Congratulations on the purchase of your new
Nano Phono V2 / Nano Phono “H” V2
MC/MM
phonostage. The
Nano Phono V2 / Nano Phono “H” V2
features a power switch: we recommend
that you keep the unit switched on in order to maintain a constant temperature for the electronic
parts inside (this uses very little power). The new
Nano Phono V2 / Nano Phono “H” V2
also has a
built-in volume control unit.
- Set up -
IMPORTANT!
First, select either the MC (moving coil) or MM (moving magnet) mode according to your cartridge
type, by inserting the removable jumpers into the relevant positions on the bottom of the unit
(one each for left and right channels). The subsonic-filter function can also be adjusted by
inserting jumpers into the relevant points on the bottom of the unit: if the jumper is inserted, then
the subsonic filter is
OFF
. If the jumper is not inserted, then the subsonic filter is
ON
.
The next step is to connect the ground wire of the turntable/tonearm with the
Nano Phono V2 /
Nano Phono “H” V2
. Make sure that the gain control is set to its lowest volume before connecting
the
Nano Phono V2 / Nano Phono “H” V2
to your MC/MM cartridge and preamplifier.
Finally, the very last thing to do is to connect the power supply to the mains and press the power
switch to the “ON” position.
- Attention -
Never cover or put anything on top of the
Nano
Phono V2 / Nano Phono “H” V2
as this could lead
to overheating of electronic parts.
If the unit a longer time not in use, please press the button on top of the device. If the device is
not in use, disconnect it completely from the power supply by removing the main plug from the
socket.
Standby mode
- Notice -
1. If you are using the
Nano Phono V2 / Nano Phono “H” V2
with a two-pin mains plug, you may
notice that inserting the plug into the mains socket one way round gives a slightly better sound
than the other way.
Experiment to identify which is the optimum position.