Double Matrix
Professional
User
manual
Page 13
clearaudio electronic GmbH 2012
6. Machine maintenance
6.1 Changing the microfiber strips
This procedure will be easier if you remove the upper cleaning arm.
Releasing the upper cleaning arm
First take the rubber tube off of the upper cleaning arm (pic. 12, no.1).
Now release the positioning screws by turning them counter-clockwise until they stand
5 - 8mm further out of the housing. It is not a problem if you release the screws completely
(pic. 12, no.2).
Now you will be able to remove one or both cleaning arms. (pic. 12, no. 3)
To prevent any scratches place them on a soft surface.
Before removing the old microfiber strips, carefully note their exact position on the cleaning arms.
Peel off the old strips and clean away any adhesive residue. The surface must be clean and dry.
Remove the protection foil, place the new microfiber strips in position and press the gently onto the
cleaning arms.
Attention!
Do not place the strips over the small fluid dispensing holes.
After changing the microfiber strips reinstall the cleaning arms by reversing the process described
above.
6.2 Self-cleaning procedure
Do not place a record onto the machine during the self-cleaning process.
Depending on the dirtiness of the records after cleaning several records you should clean your cleaning
arms as dust and dirt may lessen the cleaning performance.
1.
Place the upper cleaning arm in the working position over the lower one.
2.
Press the ‘LIQUID” button for a few seconds to wet the microfiber strips.
3.
Press ‘VACUUM’ for a few seconds to dry the strips.
4.
The self-cleaning process is complete.
Pic. 12: Washing arms
1. Pull off both rubber tubes
3. Take off the washing arm
2. Unscrew the locking screws by
approximately 5-8mm
