Page 13
labels will receive the signal. If a label is a fixed group, the entire group will
receive the call signal. If the label is a party line, then every panel listening on the
party line will receive the call signal.
Remote Telephone Line Release
This function is available only if specifically enabled in the configuration program.
To hang up a telephone interface left off the hook:
1)
Push and hold the “Listen/Call” button for at least 2 seconds until it is
bright yellow to activate the call-signal mode.
2)
While holding the “Listen/Call” button,
press the talk/listen button
programmed with talk or talk with listen of the desired telephone’s label.
3)
Release the “Listen/Call” button.
Note:
In addition to hanging up the telephone interface, this will deactivate any audio
path set to the interface from anywhere in the system.
Programmable Buttons
The two programmable buttons, located in the last row on the right-hand side of
the front panel, can be programmed through the
configuration program. In default mode, these programmable buttons increase
(left button)
or decrease (right button) the crosspoint volume (see “Listen/Call”
on page 1-5).
The two programming modes are:
Local Exclusive
Allows the user to isolate an assigned talk/listen button by turning off the audio
paths from all other active (brightly lit) talk/listen buttons.
If a talk/listen button programmed as a talk is selected for local exclusive, only
other active talks will be turned off. If a talk/listen button programmed as a listen
is selected for local exclusive, only other active listens will be turned off. If a
talk/listen button programmed as a talk with listen is selected for local exclusive,
all other active talk/listen buttons will be turned off.
To activate this function:
