25
EN
Cleaning and care
ATTENTION!
■
Empty the dust container when it reaches the
MAX
mark and clean the cyclone in-
sert, motor
fi
lters and HEPA exhaust air
fi
lter regularly in order to prevent the motor
from overheating.
■
Prior to cleaning the device, always pull the mains plug out of the socket.
■
Keep the device, the mains cable and the mains plug away from water or other liq-
uids in order to avoid the risk of electrical shock. When cleaning the vacuum cleaner
make sure that no liquid gets into the device. Only the
fi
lters may be cleaned with
water. However, when
fi
tted back into the device they must be completely dry.
■
The
fi
lters are not suitable for the washing machine, dishwasher or dryer! Only air
dry the
fi
lters and do not under any circumstances use a hair dryer.
■
Do not use any corrosive or abrasive cleaners or cleaning pads for cleaning. They
could damage the surface.
Over time the
fi
lters may become discoloured. This is normal and does not
affect the functionality.
Emptying the dust container
1. Fold the carry handle of the device downwards.
2. Push the release button of the dust container and take it
out of the device by the handle.
3. Hold the dust container over an open dustbin. The dust
container should be as close as possible to the dustbin so
that the dust from the container falls only into the bin and
is not spread over the surrounding area.
4. Press the button to open the dust container. The bottom of the dust container will
open and the dirt will fall out.
5. Shut the dust container bottom again. The fastener must audibly lock into place.
6. Put the dust container in the device: Take it by the handle and insert it bottom
fi
rst
into the device. Then push the handle towards the device housing until the dust
container audibly clicks into place. Hold the device by the dust container handle and
lift it up to check that the dust container is correctly locked into place.
Cleaning the cyclone insert and motor
fi
lters
The cyclone insert is situated inside the dust container. The motor
fi
lters are situated in
the
fi
lter holder on the cyclone insert.
1. Remove the dust container from the device and empty it (see section “Emptying the
dust container”).
2. Turn the lid of the dust container as far as it will go in an anticlockwise direction.
Remove the lid.
09666_de-en-fr-nl_V1.indb 25
09666_de-en-fr-nl_V1.indb 25
28.08.2015 14:07:53
28.08.2015 14:07:53