3
INSTALLING THE BATTERY PACK
INTO VACUUM
NOTE:
To avoid damage to the battery contacts, turn
off the power switch before reconnecting the
battery. Battery must be fully engaged to insure
proper electrical connection.
1. Hold the battery by the front and carefully slide the
battery into the lower housing until it clicks in place
(Fig. 1).
2. The connector is spring-loaded. The battery needs
to be pushed fully into position.
BATTERY CHARGE GAUGE
The battery charge gauge indicates the approximate
run time remaining on the battery. When the battery
button is pressed, one to four indicators will light up,
indicating the approximate battery charge remaining as
follows (Fig. 4):
All 4 lights on: Full Charge
3 lights on: 70% Charge
2 lights on: 45% Charge
1 light on: 25% Charge
1 light on and blinking: Low battery, charge when
possible
PREPARING THE BATTERY PACK
FOR CHARGING
NOTE:
The battery pack may require approximately
2.5 hours to fully charge.
1. Plug the charger cord into the charger (Fig. 2).
2. Plug the charger power cord into 120V wall outlet.
3. The indicator light should turn red and blink while
charging and turn green when fully charged (Fig. 3).
4. Verify the charge level of the battery pack by
pressing the power level indicator button on the front
of the pack. (Fig. 4). Four lights (one red and three
green) indicate a fully charged battery. Unplug the
battery from the charger and unplug the power cord
from the wall outlet after charging.
NOTE:
Battery pack may get warm while charging.
Fig. 1
Fig. 2
Fig. 3
Fig. 4