Safety, Operations and Maintenance Manual for Floor Machines PowerDisc, R44-180, R44-Dual; Version 1.0
6
BEFORE USING THE FLOOR MACHINE
ASSEMBLY
1. The motor head and handle are
delivered separately packed.
2. First unscrew the hex screw in the shaft
adjusting unit (17).
3. The feed to handle bar (7) gently as far
as it will go into the shaft adjusting unit
(17).
4. Align the handle (1) parallel with the
wheels (9) so that the safety button on
the housing on the handle (3) is facing
to the rear.
5. Then tighten the hex screws again.
6. Wind the cord (18) around the cord
wrap (8) and the handle.
QUICKGUIDE
1. Check that the machine is in proper
condition.
2. Remove obstacles, such as furniture
etc. from the area to be cleaned. Large
pieces can be removed to opposite end
of the room from where you start
cleaning.
3. Make sure all switches are in the OFF
position.
4. All cords and connectors must have
proper protection from spray water.
5. Check all cords for damage and signs of
aging at regular intervals. The floor
machine may only be used if the cord is
in perfect condition.
