H
OW
T
O
U
SE
Y
OUR
D
UAL
S
UCTION
S
YSTEM
V
ACUUM
Routine Maintenance
For maximum performance from your vacuum, check and maintain vacuum
parts regularly.
Replacing the Dust Bag
Check the Dust Bag weekly. Replace the Dust Bag when it is near full or when
cleaning suction diminishes. Never reuse a Dust Bag.
WARNING:
To avoid electrical shock or injury from moving parts, always turn OFF
the Power Switch and unplug the Power Source Plug before performing maintenance
or trouble shooting. Always unplug by grasping the Power Source Plug; NEVER
pulling on the Power Cord to unplug.
Tip:
Vacuuming new carpet or vacuuming fine powders may clog the Dust Bag.
Check Dust bag often.
Unplug vacuum by grasping and pulling on the Power Source Plug.
Unzip Cloth Bag. Remove collar retainer by pressing on the two tabs and pulling the
top towards you. Dispose of Dust Bag.
Slide collar of new Dust Bag completely into collar retainer.
Push collar retainer back into position and secure in place.
Tuck the remainder of the Dust Bag completely inside the Cloth Bag. Make sure it
lays flat, top to bottom, without bunching. Zip Cloth Bag.
Cleaning the Dust Tube
The vacuum features Dust Tube designed to optimize cleaning power. For best per-
formance, routinely check and clear excess dust and other debris.
Note:
Cover floor with newspaper to catch any loose material or dust removed dur-
ing cleaning.
Release Bag Tension Spring.
Remove Filter Cover screw and then remove Filter Cover.
Unplug Connector Plug.
Locate the Tube Release Button at the top of the Powerfoot. The Tube Release
Button is hidden under a Rubber Collar on the side of the Dust Tube and can be
pressed through the Rubber Collar. Lift off the Dust Tube while pressing on the Tube
Release Button.
Use a wire brush to clean out the inside of the Dust Tube and the top section of the
Powerfoot where they connect.
Reconnect the tube with the Powerfoot. It should snap into place. Make sure that
the tube release button on the Tube lines up with the Tube Release Button on the
Rubber Collar.
Plug the Connector Plug back into base of vacuum.
WARNING:
To avoid electrical shock or injury from moving parts, always turn OFF
the Power Switch and unplug the Power Source Plug before performing maintenance
or trouble shooting. Always unplug by grasping the Power Source Plug; NEVER
pulling on the Power Cord to unplug.
