Pro Ox 5900-BT-AIR Installation & Startup Guide
Page 16
www.cleanwaterstore.com
Rev. 02-26-2020
Using the Optional Chlorine Side Tank System
The chlorine side tank feature allows bleach to be drawn during Air Draw
cycle. In the Legacy View App this is referred to as “Pulse Chlorine Setting”
Chlorine has a very good effect on the Pro-OX media, cleaning and restoring
the Pro-OX. This helps eliminate slime and rust build-up inside the filter
and keeps seals and spacers cleaner.
No chlorine is added or enters into
the water that enters the home.
NOTE: Chlorine works a little better than peroxide but if desired the
Pro-OX-BT-AIR can use hydrogen peroxide in place of chlorine bleach.
NOTE: Never mix peroxide and bleach together!
1.
See “Regeneration Cycle Step Programming” Page 14 and make sure
J-2 or J-3 is active. J-2 setting means that approximately 8 ounces (1
cup) of chlorine solution will be drawn in. Set to minimum J-2 for but
could be set to J-3 to allow more chlorine solution to be drawn in.
2.
Chlorine is only drawn in when the system goes through a
“regeneration” or backwash-rinse cycle not on Air-Only nights.
3.
Remove plug on side of 5900-BT valve and attach the 3/8” black tubing from side tank to
the control valve. Make sure to use a back-up wrench on the metal fitting when tightening.
4.
Attach other end of tubing to the chlorine side tank.
5.
Add 2 Gallons of distilled, softened or bottled water & 1/2 gallon 5%
to 7% non-scented household bleach or (7% hydrogen peroxide) to
side tank. (4 parts water to 1 part bleach or peroxide)
6.
Next time Air Charger Pro-OX Filter does a regeneration
chlorine will be drawn in during Air Draw Cycle.
7.
Check side tank every 1 -2 months and add additional
chlorine as needed.
