PRE-FILTER CHANGE
If this vacuum is used to collect hazardous material, appropriate personal protective equipment may be required.
The pre-filter should be replaced if clogged or visibly dirty
1. Safe the Vacuum
• Disconnect the vacuum from power source
2. Remove the Power Head
• Unlatch the Power Head from the tank
• Lift the Power Head and attached HEPA filter off the tank by the top handle
• Carefully sit the Power Head on the floor - avoid damaging the HEPA filter
3. Remove the Pre-Filter
• The Pre-Filter is wrapped around the HEPA filter and secured with Velcro
• Find the seam and carefully peel the Velcro apart
• Dispose of the Pre-Filter according to your company policy
4. Install a new Pre-Filter
• Unfold a new Pre-Filter and remove the thin Velcro cover strip from the Velcro hooks
• Wrap the Pre-Filter tightly around the HEPA filter
• Secure the Pre-Filter by adhering the Velcro hooks to the side of the Pre-Filter
5. Replace the Power Head
• Sit the Power Head on the tank
• Rotate the Power Head so that the switch on the Power Head is in line with the inlet port on the vacuum tank
• Latch the Power Head to the tank
Repair or Warranty Contact
Clayton Associates, Inc.
•
1650 Oak Street
•
Lakewood, New Jersey 08701
•
P.+1-732-363-2100 F.+1-732-364-6084
www.DustlessMadeSimple.com
•
Page 8
