Installation in the Nord Modular G2 Engine
1. Remove the detachable power chord and then remove the 5 black panel screws on the front and the 4 black
screws on the rear panel.
2. Gently slide the red lid forward about half a centimeter, then lift up the lid.
Warning! If you don’t have an anti-static mat, you have to make sure your free hand is grounded while
handling the Expansion board.
3. Remove the three screws that hold the large board (see the figures on previous page) and remove the washers.
Replace the screws with the three enclosed posts. Use a wrench to secure the posts. Hold the Expansion board by
the outer edges so you don’t touch any traces or components. Fit the Expansion board firmly on the two sockets.
Secure the Expansion board on the posts with the three previously removed screws and washers.
4. Put the lid back down approximately half a centimeter in front of the bottom panel so it doesn’t touch the
three LEDs.
5. Gently slide back the red lid and make sure the LEDs fit in the holes in the front.
6. Put all the black panel screws back on. Don’t forget the screws on the rear.
When you power on the G2 Engine you will now have the possibility to increase the polyphony in your patches
to twice the original.
