3
Mounting
The unit should be positioned so that the airflow is
not obstructed by any part of the doorframe.
When installed the top of the heater case should
be a minimum of 200mm from the ceiling.
Installation
Carefully unpack the unit and remove the top cov-
er fixing screws. The heater may be mounted using
the mounting bracket provided.
Remove mounting bracket screws, allowing the
mounting bracket to be removed from the unit.
Making sure that the mounting bracket is horizon-
tal, fix the bracket to the wall using 4 x No 8 wood
screws. Place the unit on the mounting bracket
ensuring the washer is positioned as in diagram.
Tighten screws to hold the unit at the required an-
gle.
Refit the cover.
Wall bracket assembly
The heater may also be mounted directly onto a suitable wall or bearer by four No. 8 wood screws
through the holes provided in the back of the unit casing. Keyhole slots are provided for the top two
fixings.
Electrical connections
These units are suitable for connection to a 230/240 volt 50 Hz single phase ac supply, except for the 220
volt models. The heaters consume 3kW & 4.5kW respectively at 240 volts when switched to the full heat
position.
Model HE7402RX (see fig 3)
–
3 kW
Model HE7420RX (see fig 3)
–
4.5 kW
The appliance should be connected to the supply via a circuit in which there is an all-pole switch. Test
for correct operation and refit the cover.
41001454 Iss 05
