41000402 Iss 10
INSTALLATION/HANGING
Note: The appliance weighs 17 kg
Note: Optimum height above floor: 3.0 to 3.5 metres
1
Split and remove shroud
A pair of machine screws hold each shroud half together at each joint.
A machine screw secures each shroud half to each appliance beam.
Remove these machine screws and slide each shroud half off the appliance base panel.
Note: The base panel fits inside the shroud halves.
The diffuser is already clipped into and under the base panel and need not be removed.
2
Hanging Rod Positions
With the shroud removed the two appliance beams reveal the holes/slots shown and dimensioned below. It is
required that two
∅
10 mm hanging rods (stud bars) support each appliance beam. The rods pass through and
into each appliance beam. Support washers together with nuts locate and lock the appliance beams after
adjustment to level the appliance.
3
Replace Shroud Halves
The reverse of ‘1’ above. Slide shrouds beneath and around base panel. Secure each shroud half to each
appliance beam with machine screws. Screw shroud halves together at each joint.
