Clatronic AE 3666, Instruction Manual, Page: 33 / 58

33
Stop Operation And Disassembly
1. Set the speed control (10) to “ 0 ” position and wait until the
ilter / blade (4) has come to a complete standstill.
2. Disconnect from mains power supply.
3. Press the spout (6) upwards to prevent subsequent
dripping.
4. Remove the pusher (1) from the chute (2).
5. Take the juice jug to the side and lower the locking bar (8)
into the disengaged position.
6. Remove the lid (3).
7. Remove the pulp collector (11).
8. Remove the ilter / blade unit (4) from the base (9) by
grasping the ilter / blade (4) at its upper edge with two
hands.
WARNING risk of cuts!
The ilter / blade unit (4) has sharp knives!
Only lift it on its outer edge.
9. Then pull the ilter / blade (4) in an upward direction until
the ilter / blade unit (4) is separated from the main base (9).
NOTE:
Do not remove screws from the blade (4). The ilter and
the blade (4) are one piece. They are not meant to be
separated.
Cleaning
WARNING:
• Before cleaning always disconnect from mains power
supply.
• Under no circumstances should you immerse the appli
-
ance in water for cleaning purposes. Otherwise this might
result in an electric shock or ire.
• The ilter / blade (4) is very sharp! Danger of injury!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Do not leave the pulp to dry on the ilter / blade (4). The
ine pores will clog and become useless.
Tip
• Remove residues in the ilter /
blade (4) immediately under
running water. Use a dishwash
-
ing brush.
• For cleaning the outside of the
appliance, use only a damp
washing-up cloth.
Pusher (1), Lid (3), Filter / blade (4), Receptacle (5), Pulp
collector (11)
WARNING in regard to risk of cuts!
The ilter / blade (4) is sharp!
CAUTION:
The attachments are not suitable for dishwasher. Heat
and aggressive cleaning agents may warp or discolour the
attachments.
• Clean these components in a rinsing bath.
• Clean the ilter / blade (4) with a dishwashing brush.
• Rinse with clean water.
• Only assemble the appliance when all parts have been dried.
Storage
• Clean the appliance as described. Let the accessories dry
completely.
• We recommend that you store the appliance in its original
packaging when it is not to be used for a longer period.
• Always store the appliance at a well ventilated and dry
place outside the reach of children.
Troubleshooting
Malfunction
Possible cause
Remedy
The appliance
does not
function.
The appliance is not supplied with
power.
Check the outlet with a different device.
Insert the power plug correctly.
Check your domestic fuse.
The locking bar (8) has not been closed. Check if all components were properly attached.
The appliance is defective.
Contact our Service or a specialist.
The juice quanti
-
ty is small.
Wrong fruit type. Select a fruit type producing more juice.
Juice cannot be extracted from small berries in the ilter / blade (4).
Too much residue in the ilter / blade (4). Clean the ilter / blade (4).
Loud noise and
imbalance during
operation.
Bad assembly. Check that all components have been installed correctly.
Too much residue in the ilter / blade (4). When processing larger quantities clean the ilter / blade (4)
in-between.