14
:
With the hood installed
above a hob, there should
always be a pot or pan on
the hob zone or ring that is
in use.
:
We recommend that at least
two people install this hood.
Your Cooker Hood should only be fitted on a wall on the underside of a cabinet
unit.
Do NOT position it any less than 7
5
0 mm (7
5
cm) above the hob.
Before Installing, Remove the metal anti-grease filter (see page 9).
NOTE:
Y
OU HAVE THE CHOICE OF FITTING YOUR COOKER HOOD TO A DUCTING HOLE THAT WILL
EITHER GO ABOVE YOUR COOKER HOOD OR BEHIND IT
.
(E)
WALL INSTALLATION
1)
Position the hood against the wall and mark the positions for the
supporting bracket bolt holes (see Fig. 4 below) of the exhaust hole (this
hole must be 130mm in diameter).
2)
Drill these holes into the wall using a 6 mm diameter drill bit. If you
intend to use your Cooker Hood as an extraction fan, you will need to fit
a ducting kit through this that will connect to your appliance.
3)
Insert the raw
plugs into the holes and then insert the top screws
part way, so that the screws stick out by 10mm.
4)
Hang the hood up on the screws. Insert the bottom screws.
5)
Tighten the screws the rest of the way in.
6)
(E) For the extraction function, connect the exhaust outlet pipe to
the collar strip. Find the screw holes in the top and rear of the
cooker hood. Tighten the bolts from inside the hood.
INSTALLATION INSTRUCTIONS
– installing your Cooker Hood
PLEASE NOTE THAT YOU WILL HAVE TO
DECIDE BEFORE INSTALLING YOUR
COOKER HOOD WHETHER YOU WANT IT
AS AN EXTRACTION FAN! THE
INSTRUCTIONS FOR EXTRACTION FAN
MODE WILL BE MARKED ‘(E)’ BELOW
ALL SCREWS,
RAW
PLUGS,
ETC. COME
WITH YOUR
COOKER HOOD!