w w w . c l a s s i c
e x h i b i t s . c o m
Step 2
Page 2 of 5
866.652.2100
© 2013
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX - SEG Backwall Assembly
8
9
10
11
12
13
14
15
16
17
17
When
assembled
Item
Qty Description
8
1
95.75” TSP49 Vertical Extrusion
9
1
95.75” TSP49 Vertical Extrusion
10
1
67.692” TSP49 Curved Horizontal Extrusion
11
1
67.692” TSP49 Curved Horizontal Extrusion
12
1
92.168” Z45 Vertical Extrusion
13
1
95.75” TSP49 Vertical Extrusion
14
1
95.75” TSP49 Vertical Extrusion
15
1
96.5341” TSP49 Curved Horizontal Extrusion
16
1
96.5341” TSP49 Curved Horizontal Extrusion
17
2
92.168” Z45 Vertical Extrusion
Steps:
1) Connect curved horizontals [10,11] to verticals (8 & 9) as shown.
2) Connect curved horizontals [15,16] to verticals (13 & 14) as shown.
3) Attach vertical [12] between horizontals [10,11] as shown.
4) Attach verticals [17] between horizontals [15 & 16] as shown.
5) Apply graphic to SEG groove as shown in detail.
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
Graphic: To Ensure Proper Fit
It is important to first insert
graphic into each alternate
corner then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C
TSP49
Lock
Tighten setscrew
to secure
extrusions
TSV1 Lock Detail
