w w w . c l a s s i c
e x h i b i t s . c o m
Step 1
Page 1 of 2
866.652.2100
© 2008
WHEN DISASSEMBLING TIGHTEN ALL KNOBS TO PREVENT LOSS DURING SHIPPING
Order #xxxxx - Banner Station A - Assembly
Graphic Attachment
Attach graphic to Velcro
located on back of
assembled banner stand.
Part Number
10
11
12A
12
13
Step 1:
NOTE: Can be assembled either face down on floor then lifted
upright or upright as shown in drawings.
A) Connect vertical leg assemblies [10 and 11] together by connecting horizontal extrusion
[13] between assemblies tightening BLACK knobs on backside of extrusion making sure Velcro
faces toward BACK and placing it about one inch up from bottom and tightening.
B) Connect vertical extrusions [12 and 12A] to leg assemblies [10 and 11] using vertical connection
bar as shown.
C) Connect upper horizontal extrusion [13] between verticals [12 and 12A] placing it about one
inch down from top.
NOTE: Make sure the lock is flush with extrusion before tightening. If lock will not fully
engage, gently rock lock and extrusion back and forth while turning knob until lock
fully opens.
Description
Left Leg Assembly w/ A10 Clamps Attached
Right Leg Assembly w/ A10 Clamps Attached
Upper Curved Vertical w/ A10 Clamps Attached
Upper Curved Vertical
23”w Horizontal
10
11
12A
12
13
13
Black
Knob
Turn Knob Clockwise
to Tighten Lock
STAR
indicates location of
knobs on BACKSIDE of unit.
Vertical
Connection Bar
NOTE: When assembling horizontals they should
be placed approximately one inch from TOP and BOTTOM.
Slide
horizontal into groove
Assure
that a good
connection is made
and tighten to secure.
Slide Connection Bar into lower
leg assembly. Slide upper vertical
over bar and secure both.
Rear View of Display
Step 1
