7
Fig. 3
Fig. 3a
Fig. 4
2X
B1
B2
k
A
k
G
F
F
E
D
D
C
C
H
G
F
F
k
C
C
B1, B2
Remove protective
plastic caps from the
metal tubes on the
side mounting bars
[B1 and B2] prior to
assembly.
E
ASSEMBLE THE FRONT AND BACk HOOP POLES (FIG. 4)
11. Insert the front top poles [E] into the front bottom poles [D].
Install each assembled front pole into the vertical tube on the
top of each side of the mounting bars [B1 and B2].
12. Insert the back hoop side poles [F] first into each side
mounting bar [C]. Insert another pair of back hoop side poles
[F] into the tops of the ones installed on the side mounting
bars [C].
13. Insert the back hoop corner poles [G] into the tops of the
installed sections of back hoop side poles [F]. Finish by
inserting the back hoop top pole [H] into both back hoop
corner poles [G]. You may find it helpful to twist the pole
when inserting it into a plastic sleeve.
Note: It may help to place the parts flat
on the ground for easier assembly.
Note: The back hoop side and corner
poles each have clear plastic sleeves on
one end. The frame hoop top pole DOES
NOT have clear plastic sleeves.
Note: Assemble frame on a clean flat surface
next to your snow thrower for easy mounting.
ASSEMBLE THE BASE OF THE FRAME (FIG. 3)
6. Slide each side mounting bar [B1 and B2]
through an upper mounting post [K].
(Fig. 3a)
7. Snug (do not fully tighten) bolts on upper
mounting posts [K], so that they can be
adjusted when installing frame on lower
mounting posts [L].
8. Connect the center mounting bar [A] to both
side mounting bars [B1 and B2] by engaging
the spring loaded pins.
9. Insert the mounting bar ends [C] into the side
mounting bars [B1 and B2] by engaging the
spring load pins.
10. Repeat on other side.
