PRE-DELIVERY CHECK LIST
DELIVERY CHECK LIST
INTRODUCTION
OWNER’S RECORD
THANK YOU
Thank you for purchasing a CLASSEN Aerator
READ THIS MANUAL
Read this manual carefully in its entirety. It contains safety,
operating, maintenance, and adjustment instructions for your
Aerator. By following the operating and maintenance instruc-
tions you will prolong the life of your equipment and maintain
its maximum efficiency. Failure to do so could result in per
-
sonal injury or equipment damage.
This manual should be considered a permanent part of your
Aerator and should remain with it if you sell it.
WARRANTY
Refer to last page.
MEASUREMENTS
U.S. Units of measure are used in this manual.
SERIAL NUMBERS
Write frame and engine serial numbers, plus model numbers
in “Owner’s Record” section below. You may need these
numbers when you order parts. The serial number stick plate
is located on the right rear of the Aerator frame.
ORDERING PARTS
When ordering parts, always give the serial number and
model of your Aerator as well as the quantity, part number and
description of the part needed.
DIRECTIONS
“Right Hand” and “Left Hand” sides of the Aerator are deter-
mined by facing the “back” of the Aerator as you would oper-
ate the machine.
DATE PURCHASED _________________________________
AERATOR MODEL NUMBER_________________________
AERATOR SERIAL NUMBER _________________________
ENGINE MODEL NUMBER __________________________
ENGINE SERIAL NUMBER___________________________
Check the following before you deliver the Aerator to the
customer.
1. Guards and shields fastened in place.
2. Decals fastened and legible.
3. Weight bar installed.
4. Gas lever on engine turned on.
5. All lubrication points greased.
6. 6:1 gearbox oil level.
7. Engine oil level.
8. Air cleaner.
9. Touch up scratches. 10. Chain(s) tight.
11. Lowering handle working properly.
12. Control handle(s) working to tighten V-belt(s).
13. Add fuel, start engine, test run.
DATE SET UP __________/__________/__________
Review the operators manual with the customer.
1. Schiller Grounds Care, Inc. warranty.
2. Safe operation and service.
3. How to use controls.
4. Operating the machine correctly.
5. Transporting the Aerator.
6. Correct fuel and lubricants.
7. Daily and periodic inspections.
8. Changing oil after break-in period.
9. Servicing the Aerator regularly and correctly.
10.Schiller Grounds Care, Inc. parts and service.
11. Give the customer the operators manual and encourage
customer to read it.
DATE DELIVERED __________/__________/__________
SIGNATURE _______________________________________
1
