ADJUSTMENTS
NEUTRAL ADJUSTMENT
1. Put shift lever in Neutral Position (N).
Figure 1
2. Loosen locking nut A on clevis, them remove
bolt B and turn the clevis one way or the other
to adjust neutral.
Figure 2
.
3. To check neutral setting, reassemble with
control in neutral. Start the engine and pull pin
C out.
Figure 3
. Increase engine RPM. The
machine should NOT move. If machine moves,
then repeat Steps 1-3 until set properly.
BELT ADJUSTMENT
1. Remove belt cover.
2. Loosen the pulley andmove up the slot for
tighter belt tension.
Figure 4
3. After tension has been adjusted, check the over
center adjustment.
4. Loosen bolt
D
and move to where the lever
snaps over center and stays engaged.
Figure
5
Note: Too much over center may cause the
belt to get loose.
5. Reinstall belt cover.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
13
PRO
SOD CUTTER
