10
HTS-20
CONTROLS
CONTROLS
THROTTLE (A)
Controls engine speed and vacuum suction level.
CHOKE (B)
Move to the “CHOKE” position to apply the choke.
Move to the “RUN” position to remove the choke.
FUEL SHUT OFF (C)
Move to the “OFF” position to shut off the fuel
whenever transporting the machine by trailer or truck
or during storage. Move to the “ON” position before
starting the engine. The “OFF” position also can
be used to “KILL” the engine as a “KILL” switch is
combined with the fuel shutoff.
FREE WHEEL HANDLE (D)
Pull the free-wheel rod out to engage the
transmission. Push it back in to disengage.
RECOIL STARTER HANDLE (E)
Pull to turn over the engine to start it. Guide the
recoil starter handle back to the rope guide for best
rope life. Allowing the rope to snap back will shorten
rope life.
ENGINE SWITCH (F)
Move to the “OFF” position to stop the engine. Move
to the “ON” position before starting engine.
BRAKE ROD (G)
Pull brake rod up and to the left (from operators
position) to disengage parking brake to push or use
the hydro transmission. When done using the unit,
pull brake rod all the way up and then to the right
allowing it to rest in the groove to engage parking
brake.
DEPTH ADJUSTMENT LEVER (H)
Use the depth adjustment lever by first pulling it out
to the right of the unit and then moving it toward the
front or rear of the machine to select the desired
depth to cut. Release the lever to allow it to lock into
the desired setting.
RIGHT CONTROL HANDLE (I)
Pull right control handle up to move the unit forward
or push down to move in reverse.
LEFT CONTROL HANDLE (J)
Push down left control handle to engage the main
shaft and release to disengage.
