Classe Audio TUNER ONE, Owner'S Manual, Page: 9 / 18

-
9
-
WAND AND CONTROLS
TUNER-1 Wand
Remote Control Wand operation.
1
Direct Digit Entry
Put the tuner into tune mode by pressing TUNE on
the handset. The display will show the current
frequency.
Using the number area on the handset enter the
desired frequency.
For example: To tune to 102.5MHz press
1 0 2 5 0 .
When the final 0 is pressed the tuner will tune to
that frequency.
If there is an invalid digit entry the tuner will
default to the nearest possible value for that
digit.
The selected frequency can be modified in 50
kHz steps by pressing the
™ and Š buttons.
Holding ™ or Š will tune continuously.
2 Storing a Preset
With the TUNER-1 in tune mode press STORE .
The TUNER-1 will show the next lowest
available preset location in which the frequency
can be stored.
Press
™ or Š to select the desired preset
number.
Once the location has been selected the preset is
stored by pressing
STORE again.
If there is already a preset stored in a location
then the display will show
St. to indicate that
you will overwrite a previous preset if the store
command is executed.
3 Recalling a preset
Put the TUNER-1 into preset mode by pressing
PRESET . Step through the stored presets using
the ™ and Š keys, or enter the preset number
directly using the numbers on the handset. To
enter a two digit preset, hold the first digit until
it jumps to the left on the display, then enter the
second digit. The selected preset station will be
heard immediately after the second digit is
input.
Selected preset number will remain in display.