TECHNICAL DATA
OP 1335
HVLP PROFESSIONAL SPRAY PAINT GUN
• Standard nozzle: 1,4mm
• Option al nozzle: 1,3mm, 1.4mm, 1,6mm, 1,8mm, 2,0mm
• Air Inlet: 1/4» NSP
• Air consumption: 250 L/Min (HP)/2
• Pattern 300mm ~ 320mm
• Working pressure: 30 – 43 PSI (HP)/ 15 – 28 PSI (HVLP, LVLP)
OPERATION
CLEANING AND GUN CARE
• Flush gun thoroughly with solvent.
• Clean air nozzle with brush. Do not place the gun into solvent.
• Clogged holes should never be cleaned with improper objects, at the smallest amount of damage may badly
influence the spray pattern.
• Slightly oil movable parts.
Starting
• Use spanner to tighten the fluid nozzle.
• Check for correct tightening of stuffing box to avoid any air leakage.
• Air hose should be blow out before fitting with the air connection.
• Before using this gun, make sure that it is carefully bushed with solvent.
Adjustment of the jet width
To adjust jet width., rotate the stepless adjuster. The spray pattern can be altered from flat to round spray as required.
Air quantîty control
To set the air to material ratio, adjust the stepless air micrometer. While gun is in operation, never dismantle
hollow screw for removal of micrometer by hexagon socket screw key.
Exchange of nozzle set
When changing to another nozzle size, make sure that the complete nozzle set is exchanged. A set comprises
of air cap, paint needle and paint nozzle. Insert paint nozzle before putting in paint needle.
Exchange of the self tensioning sealings
The needle seal is effected by a teflon seal and a needle packing with self-tensioning compression spring. To
change the packing, please use the screwdriver.
