OM 3425
WHEEL HUB BEARING TOOL SET HUB 2.1 Ø72mm
WARNINGS
• Always ensure the threaded force screw of the tool is lubricated with suitable high load bearing grease and the
thread is clean and free from debris.
• We recommend the use of molybdenum Disulphide grease, black grease or CV joint grease).
• Use of power tools for tightening the force screw will void the warranty.
• Always read and follow the manufacturers instructions
• Always wear gloves, safety goggles and safety boots
• Always tighten components to the manufacturers recommended torque settings
• Cleanliness is essential, any dirt or debris left within the hub housing could prevent the bearing from seating
properly and cause premature failure.
• Always clean the area of the back of the hub prior to removal of the bearing to prevent dirt and debris from
damaging the housing and jamming the puller bush/force screw thread.
• The kit utilises an open force screw bearing design to allow ease of cleaning. Ensure the bearing is kept clean
and free from dirt and debris. Lubricate with light oil.
• Use of this kit requires the partial dismantling of the vehicles braking system and drive shafts, always refer to the
manufacturers instructions.
• CLAS Equipments cannot be held responsible for any damage or injury to property or person how so ever
caused.
CONTENTS
A. Insertion clamshells
B. Force Plate
C. Removal Clamshells
D.Clamshell Securing Screws
E. Force Pins
F. Force Nut
G. Extraction Adaptor
H. Main Force Screw
I. Insertion Adaptor
J. Hex Key (6mm)
K. Thrust Bearing
A
I
B
C
D E
J
G
H
F
