AP 0080
1 DRAWER TOOLBOX-FRIDGE 50l
PREPARATION
1. Remove the carton and foam packaging (including the bottom foam) before use.
2. Clean the device before use.
3. After moving the appliance, wait 30 minutes before switching it on. On: close the door and
connect it to the power source, turn on the lamp by the switch on the control panel, the lamp is
on. After one and a half hours, the temperature inside should have dropped significantly, and this
indicates that it is working properly.
4. After connecting to the power source, the unit should remain empty for one hour.
SETTING
1. Adjust the storage temperature via the temperature controller located inside the product (see
photo), adjust the temperature according to the ambient temperature but also according to the
contents to be cooled.
2. Please find the picture of the temperature adjustment button. The temperature adjustment
capability is noted from "1" to "5", adjust the storage temperature by turning the temperature
controller clockwise. The higher the number, the colder the temperature. The knob can be
turned as desired, except that we cannot turn it from "5" to "1" clockwise. The factory has set the
temperature to "3".
3. The «0» position indicates that the unit stops working.
STORAGE OF ITEMS
1. Do not put a lot of items in the appliance at one time, you must leave some space around the
contents to allow fresh air to circulate inside the appliance. Keep bottled items away from the
inside walls of the appliance, so that they do not freeze and break.
2. Do not put hot food directly into the appliance until it is cool inside the room. This will help to
reduce energy consumption and extend the life of the compressor.