E
N
G
LI
S
H
4. Setting the thermostat to heat or cool
There is a jumper on the back of the circuit
board for setting the thermostat’s heating or
cooling function.
Tip!
Make this selection before programming;
otherwise stored programmes will be lost.
4.1 Change the jumper to
HEAT
if the
thermostat is to be used for heating,
change it to
COOL
if the thermostat is to
be used with a cooling system.
4.2 Press
Reset
[ 4 ] to confirm the choice.
Note:
When reset is pressed, the
thermostat reverts to its factory setting.
5. First slide the left side of the thermostat behind the tabs on the back cover then slide
the right side of the thermostat onto the back cover until a click is heard and the parts
are lined up. Screw the screw back into the bottom of the battery compartment.
6. The thermostat requires two LR6/AA batteries. Insert the batteries into the battery
compartment and close the cover. Make sure to insert the batteries according to the
markings in the battery compartment. When the batteries have been inserted the
display will show the current time and temperature.
