9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
UNPACKING & ASSEMBLY
When unpacking, check for damage or omissions etc. Any found should be
reported to your CLARKE dealer where the lathe was originally purchased. Do
not discard the packaging until the lathe is assembled.
The numbers in the following assembly instructions refer to the parts lists and
diagrams on pages 18-22.
The following items are supplied loose:
ASSEMBLY OF THE STAND
1. Assemble the front & rear legs,
supports and top plates using the
coachbolts, nuts and washers as
shown in Fig 1.
2. Assemble the stand loosely before
tightening all the fixings together.
3. With the help of an assistant,
position the lathe over the top
plates and align the holes in the
lathe bed with the holes in the
stand top plate. Secure with the bolts supplied and tighten them evenly.
WARNING: DUE TO THE WEIGHT OF THE LATHE BED ASSEMBLY IT IS
ESSENTIAL THAT TWO PEOPLE PERFORM THE UNPACKING, ASSEMBLY AND
POSITIONING.
1 x Tool Rest
2 x 32mm Open Wrench
1 x Tool Rest Holder fitted?
1 x 10mm T-Wrench
1 x Face Plate
1 x Fixings Pack
1 x Headstock Centre Spur
1 x Drift Rod
1 x Tailstock Spur
3 x Cutting Tools
1 x Copy Follower Assembly
4 x Stand Legs
1 x Tool Holder Locking Handle (fitted) 2 x Stand Long Support
3 x Leadscrew Handles
2 x Stand Short Supports
1 x Face shield
2 x Stand Top Plates
2 x Hex Keys (S3 & S4)
Summary of Contents for WOODWORKER CWL1000CF
Page 24: ......
