Using Your Folding Workbench
To prepare the unit for work, first ensure you are on a firm flat surface. Open the
legs, and push down on both side stays until they go over centre and lock. Test the
stability of the table by rocking it vigorously. To close the unit, pull up on each side
stay, and bring the legs together.
Each end of the moveable vice jaw can be moved independently, thereby
allowing tapered work to be gripped, and when used in conjunction with the
vice pegs, large and irregular shaped work may be accommodated.
NOTE: The vice jaws are capable of exerting considerable force. Be extremely
careful therefore when clamping your work. Use only that force which is necessary.
The vice pegs are grooved along their length, allowing round or tubular work to
be held, such as dowels, tubes etc.
It may be necessary to steady the workbench whilst working, by placing a foot or
a weight, such as a sand bag or similar, on to a cross member. Take care not to use
excessive force or weight, as serious damage can result.
Parts List & Diagram
For Parts and Service, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
No. Description
Qty Part No.
1
Worktop
2
GD10001
2
Slide Base
2
GD10002
3
BoltHex
4
GD10003
4
Cross Members
2
GD10004
5
Leg Frame
2
GD10005
6
Plastic Feet
4
GD10006
7
Flat Washer
8
GD10007
8
Wood Screws
16
GD10008
9
Bolts
8
GD10009
10
Nuts 6mm
8
GD1001O
11
Locknut 8mm
4
GD10011
12
Vice Pegs
4
GD10012
13
FlatWashers
8
GD10013
