4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ELECTRICAL CONNECTIONS
These pumps MUST be fitted with a Residual Current Device (RCD), with a
rated residual operating current of no greater than 30mA. This is essential
when the pump is used for pumping swimming pools.
The mains lead must be connected to a standard 230 volt (50Hz) electrical
supply through an approved plug or a suitably fused isolator switch.
As the colours of the flexible cable of this appliance may not correspond with
the coloured markings identifying terminals in your plug proceed as follows:
• The BLUE wire must be
connected to the
terminal which is
marked N.
• The BROWN wire must
be connected to the
terminal which is
marked L.
• The YELLOW AND
GREEN wire must be
connected to the
terminal which is
marked E or
.
In the event that the pump is hard-wired into the electrical system, it must be
carried out in accordance with IEE regulations.
WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS
THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS
SUPPLY.
WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE
COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
BLUE = NEUTRAL BROWN = LIVE YELLOW AND GREEN = EARTH
Plug must be BS1363/A approved.
Always fit
Ensure that the outer sheath of
Neutral
(Blue)
Live
(Brown)
Earth
(Green and
a 13 Amp
the cable is firmly held by the clamp
fuse.
Yellow)
Summary of Contents for PSP195
Page 12: ......